NFISB-30 Single Phase Relay with Time Delay and Overload Protection
- Connection
- Input 220-240 Voltage
- Output is used for switching compressor, motor or other outputs while monitoring load and protecting against preset limit.It will shut the circuit down and offer time delay.
- Features
- Upon connection the LED will flash for a delay of 3 minutes, the circuit will then close and the LED will stop flashing. If the current is over the preset limit the Alarm LED will indicate Red and the relay will be shut the circuit down.
- Operation
¡¡¡¡¡¡¡¡ Upon connection hold the button for 3 seconds and the LED will rotate among Red, Green and Orange. Release the button when the desired color is displayed.Red color means the overload is set for 30 Amps, Green for 20 Amps and Orange for 10 Amps.
¡¤ If the Alarm LED is Red then push the button to reset.
¡¤ If there is no power to the load connection the alarm can not be reset. You must check your power source.
¡¤ If you depress the button while switching the power then this will override the 3 minute delay for testing purposes.
¡¤ This relay will hold its setting until physically reset. |
